LED Smart Oil

APPLICATION TOOLS

Instant LED-UV Curing Hardwax-Oil
Osmo LED Smart Oil is the ultimate one-coat industrial hardwax-oil that revolutionizes your finishing process with instant LED-UV curing. Available in a satin or matte finish, this advanced single-component system offers exceptional durability and liquid resistance, and is VOC, solvent and ozone-free. Dries instantly under LED-UV lamps, saving time and money without sacrificing quality.

Cures instantly under 395nm LED-UV lamps
Zero VOC, solvent-free and ozone-free
Only a single coat is required – no hardeners needed
Highly durable and hard-wearing – water and chemical resistant
Resists common liquid spills such as wine, beer, cola, coffee, tea, fruit juice, milk and water (DIN 68861-1A certified)
Saliva-resistant and sweatproof – safe for children’s toys
Microporous, breathable finish – will not peel, crack or flake
Optional second coat for a satin sheen

SPECIFICATIONS

Approx. Coverage

575 ft²/L (53 m²/L) with one coat

Number of Coats

1 coat = matte; 2 coats = satin

Application Temp.

+5°C to 35°C

Approx. Dry Time

Dries and cures instantly under 395nM LED-UV

Sizes

0.75L, 2.5L

5980

Clear

APPLICATION INSTRUCTIONS

Application with a white pad and Osmo 395nM LED-UV Driver

Surface Preparation: The wood surface must be clean, dry and frost-free (moisture content max. 10 %).

Recommended sanding grit for wooden floors: P100-P120
Recommended sanding grit for furniture, doors etc.: P120-P180

Osmo LED Smart Oil is ready to use. Do not thin. Stir well.
Buff one coat into the surface of the wood using a non-abrasive white pad, such as Osmo White SuperPad or similar. Apply approximately 15-20g/m2 to the wood surface and buff until no circular swirl marks remain on the wood surface.
With the Osmo 395nm LED-UV lamp or similar, pass the curing lamp over the treated area slowly at a rate of approximately 5 seconds per foot with the lamp held at a height of 4-6 inches (10-15cm) above the wood surface.
A second optional coat may be applied which will increase both surface durability and sheen.
After the first coat has cured, lightly sand the surface with P320 grit sandpaper and remove sanding dust with a tack cloth.
Apply a second thin coat of approximately 5-6g/m2 to the wood surface with a non-abrasive white pad, such as Osmo White SuperPad or similar. Buff the surface of the wood until no circular swirl marks remain on the wood surface and then cure with LED-UV lamp, as outlined above in step 3.

Once dried the surface is ready for regular use or packaging with no further cure period required.

Storage: 6 months if can is kept dry, closed tightly, and stored at temperatures between 5 °C and 35 °C. If thickened by frost, store 24-36 hours at room temperature before use.

DOCUMENTATION